CareerExamPro

Cybersecurity, CISSP, Security+ & CISA Practice Test

Network & cloud security architecture, SIEM/log triage, IAM/Zero Trust, cryptography, incident response, and IT audit/risk governance for Security+, CISSP, CISA, CISM, and CySA+.

40 questions · 2 topics · start free, no sign-up

Start practising

Mixed practice drill

10 realistic exam questions, graded as you go, with the exact rule or statute citation for every answer. Start free, no sign-up.

Timed mock exam

40 questions in 48 minutes, drawn from every topic. No answers shown until the end, then a full score breakdown, your weakest topics and a review of what you missed.

Practise by topic

Sample questions

A quantitative risk assessment evaluates a regional data center valued at $800,000 (Asset Value). Historical climate data indicates a severe flood is expected to occur once every 4 years (ARO = 0.25) and would damage 35% of the facility's value (Exposure Factor = 0.35). What is the Annualized Loss Expectancy (ALE) for this flood risk?

  1. $280,000, calculated by multiplying the $800,000 Asset Value directly by the 35% Exposure Factor for a single flood event.
  2. $70,000, derived from a Single Loss Expectancy (SLE) of $280,000 multiplied by an Annualized Rate of Occurrence (ARO) of 0.25.
  3. $200,000, derived by dividing the $800,000 Asset Value evenly across the 4-year recurrence interval without factoring in partial damage.
  4. $1,120,000, derived by multiplying the $280,000 Single Loss Expectancy by the 4-year recurrence period to project multi-year exposure.
Show the answer

B. $70,000, derived from a Single Loss Expectancy (SLE) of $280,000 multiplied by an Annualized Rate of Occurrence (ARO) of 0.25.

Under quantitative risk analysis, Single Loss Expectancy is SLE = AV × EF = $800,000 × 0.35 = $280,000. Annualized Loss Expectancy is ALE = SLE × ARO = $280,000 × 0.25 = $70,000. Dividing AV by 4 omits the Exposure Factor, while multiplying SLE by 4 inverts the ARO fraction (1/4 = 0.25).

Reference: NIST SP 800-30 Rev. 1 & ISC2 CISSP Domain 1 (Quantitative Risk Analysis)

A SOC analyst triages the following correlated SIEM events from a corporate identity provider over a 45-second window:

LOG
2026-11-18T14:02:01Z idp-auth src=198.51.100.62 user=a.garcia  result=FAILURE reason=INVALID_PASSWORD
2026-11-18T14:02:03Z idp-auth src=198.51.100.62 user=b.kim     result=FAILURE reason=INVALID_PASSWORD
2026-11-18T14:02:05Z idp-auth src=198.51.100.62 user=c.okonkwo result=FAILURE reason=INVALID_PASSWORD
... (34 additional distinct accounts, 1 attempt each, all FAILURE) ...
2026-11-18T14:02:44Z idp-auth src=198.51.100.62 user=j.patel   result=SUCCESS mfa=NOT_ENROLLED

Which attack technique best explains this log pattern, and why did it evade per-account lockout controls?

  1. A vertical brute-force attack targeting a single privileged account with an automated dictionary wordlist until the threshold resets.
  2. A pass-the-hash replay attack injecting stolen NTLM digests directly into Kerberos ticket-granting requests to bypass password validation.
  3. A password-spraying attack testing one common password across many accounts to stay below each account's lockout threshold.
  4. A session-hijacking attack replaying a stolen SAML bearer assertion across multiple federated accounts before the token expiration window.
Show the answer

C. A password-spraying attack testing one common password across many accounts to stay below each account's lockout threshold.

Password spraying (MITRE ATT&CK T1110.003) tests a small number of commonly used passwords horizontally across many usernames so no single account exceeds its failed-login lockout threshold. The single success on an account lacking MFA (j.patel) requires immediate containment, password reset, and MFA enforcement.

Reference: MITRE ATT&CK T1110.003 (Password Spraying) / CompTIA CySA+ CS0-003 Domain 2

A bank's Business Impact Analysis (BIA) establishes a Maximum Tolerable Downtime (MTD) of 8 hours, a Work Recovery Time (WRT) of 2 hours for transaction reconciliation and backlog catch-up, and a Recovery Point Objective (RPO) of 15 minutes for its wire-clearing platform. What is the maximum permissible Recovery Time Objective (RTO), and what does the 15-minute RPO govern?

  1. Maximum RTO is 6 hours (MTD - WRT), and the 15-minute RPO sets the maximum tolerable data loss governing backup or replication frequency.
  2. Maximum RTO is 10 hours (MTD + WRT), and the 15-minute RPO specifies the time required for IT staff to declare a disaster and notify executives.
  3. Maximum RTO is 7 hours 45 minutes (MTD - RPO), and the 2-hour WRT sets the minimum retention period for immutable off-site backup snapshots.
  4. Maximum RTO is 8 hours (equal to MTD), and the 15-minute RPO governs the maximum time allowed to verify restored ledger balances after cutover.
Show the answer

A. Maximum RTO is 6 hours (MTD - WRT), and the 15-minute RPO sets the maximum tolerable data loss governing backup or replication frequency.

In business continuity planning (NIST SP 800-34 / ISC2 CISSP), total recovery must fit within MTD: RTO + WRT <= MTD. With MTD = 8 hours and WRT = 2 hours, technical infrastructure restoration (RTO) cannot exceed 6 hours. RPO independently defines the maximum acceptable age of recovered data (15 minutes of data loss), driving replication and backup intervals.

Reference: NIST SP 800-34 Rev. 1 (Contingency Planning Guide) / ISC2 CISSP Domain 1 & 7

A network engineer audits an egress firewall access control list (ACL) evaluated top-down on a first-match basis:

TEXT
Rule 10: PERMIT tcp 10.20.0.0/16   any            eq 443
Rule 20: DENY   tcp 10.20.4.15/32  any            eq 443
Rule 30: PERMIT tcp 10.20.4.15/32  10.30.1.10/32  eq 22
Rule 40: DENY   ip  any            any

What happens when host 10.20.4.15 initiates an outbound TCP/443 connection to 203.0.113.50?

  1. The connection is permitted by Rule 10, because 10.20.4.15 falls inside 10.20.0.0/16 and shadows Rule 20.
  2. The connection is denied by Rule 20, because firewalls always prioritize the longest-prefix /32 host match over a broader /16 subnet entry.
  3. The connection is denied by Rule 40, because conflicting PERMIT and DENY statements on the same destination port fall through to the implicit deny.
  4. The connection is dropped and logged as asymmetric traffic unless Rule 30 is moved above Rule 10 to authorize the source IP address first.
Show the answer

A. The connection is permitted by Rule 10, because 10.20.4.15 falls inside 10.20.0.0/16 and shadows Rule 20.

Standard firewall ACLs evaluate rules sequentially from top to bottom and stop at the first match—unlike routing tables, which use longest-prefix match. Because 10.20.4.15 is within 10.20.0.0/16, Rule 10 matches first and permits TCP/443, shadowing Rule 20; specific DENY rules must precede broader PERMIT rules.

Reference: NIST SP 800-41 Rev. 1 (Guidelines on Firewalls and Firewall Policy) / CompTIA Security+ SY0-701

During vendor due diligence, a cloud HR provider delivers a clean AICPA SOC 2 Type I report dated September 30, 2026 covering the Security and Confidentiality Trust Services Criteria. What is the key assurance limitation of this report compared to a SOC 2 Type II report?

  1. A SOC 2 Type I report only covers internal controls over financial reporting (ICFR) and excludes all logical security and confidentiality safeguards.
  2. A SOC 2 Type I report assesses control design and implementation at a single point in time rather than operating effectiveness over a review period.
  3. A SOC 2 Type I report is self-attested by the vendor's internal audit team without requiring an independent licensed CPA firm's formal opinion.
  4. A SOC 2 Type I report omits the detailed system description and control listings so it can be posted publicly on the vendor's marketing website.
Show the answer

B. A SOC 2 Type I report assesses control design and implementation at a single point in time rather than operating effectiveness over a review period.

Under AICPA Trust Services Criteria (AT-C 205), a SOC 2 Type I report evaluates only the suitability of design and implementation of controls as of a specific date (point in time). A SOC 2 Type II report additionally tests and opines on the operating effectiveness of those controls across a defined observation window (typically 6 to 12 months). (SOC 1 covers ICFR; SOC 3 is the public summary.)

Reference: AICPA SOC 2 Reporting on Controls at a Service Organization / ISACA CISA Domain 1

Exams this helps with

ExamAgency / IssuerRegion
ISC2 Certified Information Systems Security Professional (CISSP)ISC2Global / Online
ISACA Certified Information Security Manager (CISM)ISACAGlobal / Online
CompTIA Security+ (SY0-701) Certification ExamCompTIAGlobal / Online
ISACA Certified Information Systems Auditor (CISA)ISACAGlobal / Online
CompTIA Cybersecurity Analyst (CySA+ CS0-003)CompTIAGlobal / Online