CareerExamPro

Risk Governance, Compliance & IT Audit practice questions

20 questions from the Security+, CISSP, CISA & CySA+ practice test.

Start practising

Risk Governance, Compliance & IT Audit practice drill

10 realistic exam questions, graded as you go, with the exact rule or statute citation for every answer. Start free, no sign-up.

Sample questions

A quantitative risk assessment evaluates a regional data center valued at $800,000 (Asset Value). Historical climate data indicates a severe flood is expected to occur once every 4 years (ARO = 0.25) and would damage 35% of the facility's value (Exposure Factor = 0.35). What is the Annualized Loss Expectancy (ALE) for this flood risk?

  1. $280,000, calculated by multiplying the $800,000 Asset Value directly by the 35% Exposure Factor for a single flood event.
  2. $70,000, derived from a Single Loss Expectancy (SLE) of $280,000 multiplied by an Annualized Rate of Occurrence (ARO) of 0.25.
  3. $200,000, derived by dividing the $800,000 Asset Value evenly across the 4-year recurrence interval without factoring in partial damage.
  4. $1,120,000, derived by multiplying the $280,000 Single Loss Expectancy by the 4-year recurrence period to project multi-year exposure.
Show the answer

B. $70,000, derived from a Single Loss Expectancy (SLE) of $280,000 multiplied by an Annualized Rate of Occurrence (ARO) of 0.25.

Under quantitative risk analysis, Single Loss Expectancy is SLE = AV × EF = $800,000 × 0.35 = $280,000. Annualized Loss Expectancy is ALE = SLE × ARO = $280,000 × 0.25 = $70,000. Dividing AV by 4 omits the Exposure Factor, while multiplying SLE by 4 inverts the ARO fraction (1/4 = 0.25).

Reference: NIST SP 800-30 Rev. 1 & ISC2 CISSP Domain 1 (Quantitative Risk Analysis)

A bank's Business Impact Analysis (BIA) establishes a Maximum Tolerable Downtime (MTD) of 8 hours, a Work Recovery Time (WRT) of 2 hours for transaction reconciliation and backlog catch-up, and a Recovery Point Objective (RPO) of 15 minutes for its wire-clearing platform. What is the maximum permissible Recovery Time Objective (RTO), and what does the 15-minute RPO govern?

  1. Maximum RTO is 6 hours (MTD - WRT), and the 15-minute RPO sets the maximum tolerable data loss governing backup or replication frequency.
  2. Maximum RTO is 10 hours (MTD + WRT), and the 15-minute RPO specifies the time required for IT staff to declare a disaster and notify executives.
  3. Maximum RTO is 7 hours 45 minutes (MTD - RPO), and the 2-hour WRT sets the minimum retention period for immutable off-site backup snapshots.
  4. Maximum RTO is 8 hours (equal to MTD), and the 15-minute RPO governs the maximum time allowed to verify restored ledger balances after cutover.
Show the answer

A. Maximum RTO is 6 hours (MTD - WRT), and the 15-minute RPO sets the maximum tolerable data loss governing backup or replication frequency.

In business continuity planning (NIST SP 800-34 / ISC2 CISSP), total recovery must fit within MTD: RTO + WRT <= MTD. With MTD = 8 hours and WRT = 2 hours, technical infrastructure restoration (RTO) cannot exceed 6 hours. RPO independently defines the maximum acceptable age of recovered data (15 minutes of data loss), driving replication and backup intervals.

Reference: NIST SP 800-34 Rev. 1 (Contingency Planning Guide) / ISC2 CISSP Domain 1 & 7

During vendor due diligence, a cloud HR provider delivers a clean AICPA SOC 2 Type I report dated September 30, 2026 covering the Security and Confidentiality Trust Services Criteria. What is the key assurance limitation of this report compared to a SOC 2 Type II report?

  1. A SOC 2 Type I report only covers internal controls over financial reporting (ICFR) and excludes all logical security and confidentiality safeguards.
  2. A SOC 2 Type I report assesses control design and implementation at a single point in time rather than operating effectiveness over a review period.
  3. A SOC 2 Type I report is self-attested by the vendor's internal audit team without requiring an independent licensed CPA firm's formal opinion.
  4. A SOC 2 Type I report omits the detailed system description and control listings so it can be posted publicly on the vendor's marketing website.
Show the answer

B. A SOC 2 Type I report assesses control design and implementation at a single point in time rather than operating effectiveness over a review period.

Under AICPA Trust Services Criteria (AT-C 205), a SOC 2 Type I report evaluates only the suitability of design and implementation of controls as of a specific date (point in time). A SOC 2 Type II report additionally tests and opines on the operating effectiveness of those controls across a defined observation window (typically 6 to 12 months). (SOC 1 covers ICFR; SOC 3 is the public summary.)

Reference: AICPA SOC 2 Reporting on Controls at a Service Organization / ISACA CISA Domain 1

Other topics